Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
- Cars of mark Skoda Felicia
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, the tool and the workplace equipment
   Operations procedure in extreme situations
   Start of the engine from the auxiliary power supply
   Change of wheels
   Поддомкрачивание and towage
   Identification of leaks
   Checks of readiness of the car to operation
   Automobile химикалии, oils and greasings
   Диагостика malfunctions of knots and car systems
   Features of the countries PDD of Europe
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

Change of wheels

The site of a spare wheel and working tools can vary, however the general order of performance of procedure remains identical to all models of cars of mark Skoda Felicia.

Preparation

At a wheel puncture try to brake immediately the car, without losing thus the control over management.
Park the car away from проезжей parts on an equal horizontal platform, whenever possible with a firm covering.
In case of need include the alarm system and expose on проезжей parts before a parking place warning triangle.
Cock a lay brake and switch a box to the first or a reverse gear (РКПП), or in position “Р” (АТ).
Prop up wedges a wheel located on a diagonal from subject replacement (as a last resort will approach pair of stones of sufficient size).
In case of a soft covering of a platform enclose under a heel of a jack something like a board piece.

Order of performance of procedure

PERFORMANCE ORDER

1. The spare wheel and tools are stored in a special well in a car luggage space. Turn away a rug and remove the cover panel. Take from a well a jack and tools. Release a clamp, take out a spare wheel and lay it under a threshold of the car near to a wheel subject to replacement.
2. Hook a screw-driver and remove a decorative cap of a disk of a wheel subject to replacement, having provided with that access to fixing bolts. In case of cast wheel disks dismantle of decorative caps is made by means of the special key which is usually a part of a standard tooling.
3. With the help баллонного a key ослабьте on a half-turn wheel bolts. If any of bolts does not give in, it is not necessary to try to shift it from a place by a rising on the key handle - address for the help to experts шиномонтажной a workshop.
4. Get a jack in corresponding домкратную a point near to the failed wheel and take care of that its heel rested against a firm covering. Rotation of the handle achieve a dense emphasis of a heel of a jack in the earth. Make sure of reliability of fixing of a head of a jack in a threshold groove.
5. Raise the car until the wheel will not come off the earth. If the wheel is lowered, take care of presence of the stock necessary for installation pumped up запаски.
6. Turn out fixing bolts, remove a wheel and, having changed its places with запаской, enclose under a car threshold close домкратной points.
7. Establish a spare wheel and fix its bolts, having tightened the last with moderate effort баллонным a key. Lower the car on the earth, take a jack and definitively tighten bolts of fastening of a wheel in a diagonal order. Establish into place a disk cap.

In summary

Take from under wheels wedges.
Lay on regular places the tool and the removed wheel.
Check up pressure of a rating established instead of the lowered wheel запаски. At absence near at hand an exact manometre on slow speed adjust the car to the nearest car repair shop where it is possible to check up pressure.
At the first possibility give a punctured wheel for repair in шиномонтажную a workshop.
At the first possibility draw bolts of fastening of a wheel with demanded effort.