Skoda Felicia

1. The fuel filter is established on the right in a back part of an impellent compartment.
2. Get under the filter drain capacity, for gathering of spilt fuel enclose rags.
3. Remove a R-shaped clamp and take from the top part of the filter the operating valve, without disconnecting fuel hoses.
4. Release collars and disconnect from filter unions fuel hoses If for fastening of hoses collars of braided type are used, it is necessary to have a bite them бокорезами, and at assemblage to replace more practical screw or worm. Try to remember an order of connection of a hose for the purpose of observance of orientation of the replaceable filter in relation to a direction of a stream of fuel.

Be ready to gathering of spilt fuel.

5. With the help пруткового a key turn out the screw of a fixing arm and remove the filter.

6. Before installation fill the replaceable filter pure diesel fuelм that will help to facilitate initial start of the engine. Establish the filter in a fixing arm and strongly fix its screw.
7. Put on a new sealing ring the valve of management and establish last on the regular place in the top part of the fuel filter. Fix the valve a R-shaped clip.
8. Connect to the filter fuel hoses (pay attention to arrows on the case of the filter near to its unions, specifying a correct direction of a stream. Fix hoses new collars. Clean drain capacity and rags. If removed, connect an air sleeve to an air cleaner and the inlet pipeline.
9. Start the engine on single turns and check up the filter on presence of signs of leaks of fuel.

Engine start can occupy slightly more than usual time that is connected with necessity of filling with fuel of cavities of a path, especially if the new filter preliminary has not been filled in.

10. Some times lift turns to 2000 in a minute, at once dumping from back to the single. Make sure of absence of bubbles in a stream of fuel in connected to ТНВД a translucent hose.