Skoda Felicia

Since 1994 of release

Repair and car operation


Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
- Engine electric equipment
   - Charge and start systems
      The general information and safety measures
      Check of a condition and battery gymnastics
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal and generator installation
      Replacement of the module of a shchetkoderzhatelja/regulator of pressure
      Check of serviceability of functioning of system of start
      Removal and starter installation
      Starter major repairs
   + System of ignition of petrol engines
   + System of preheat of diesel engines
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

c9b0dd5c

Removal and installation of the storage battery

REMOVAL

 PERFORMANCE ORDER

The negative wire always should be disconnected from the battery first of all, and be connected in last!

If the car is completed by an audiosystem of firm complete set Skoda before to disconnect the battery make sure that have a code which is required for switching-off блокиратора security system. On the models equipped with anticreeping system, do not forget to disconnect a special key system.

1. Loosen the a coupling nut also remove клеммный a clip from a negative pole of the battery.

Do not mix a wire - both have isolation of black colour.

2. Lift изоляционную an overlay and disconnect from the battery a positive wire.

3. Turn out bolts in the basis of the battery and cast away a clamping lath of fastening of the battery.

4. At a corresponding complete set, отболтите also remove распорную a bar of support of racks of a forward suspension bracket. In case of need remove the top cover of the block of a heater/fan. On petrol models remove from the basis the valve of a purge of a coal adsorber and shift it aside, without disconnecting hoses.
5. At a corresponding complete set disconnect from the top part of the battery a ventilating tube, then take the battery from an impellent compartment.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down At connection of wires to battery poles grease клеммные knots бескислотным with vaseline for the purpose of prevention of development of corrosion.

Always connect a negative wire in last turn!

On petrol models the battery detachment leads to clearing of memory of a control system of the engine about current parametres of the last. Restoration of the adaptable data can occupy some time that leads to infringement of stability of turns within the first minutes after the next start of the engine.

On the models equipped with the antijoy ride device do not forget to take a key from the main block of system.