Skoda Felicia

Since 1994 of release

Repair and car operation


Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   - System of the central injection (SPFI) the petrol engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner
      The vacuum switch of a control mean in temperature of soaked up air
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of system Bosch Mono-Motronic
      Removal and installation of assemblage of a gasoline pump and the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Dump of residual pressure in the power supply system
      Removal and installation of the inlet pipeline
      Check of functioning and adjustment of system of injection
      Neetilirovannoe fuel - the general information and use rules
   + System of the distributed injection (MPFI) the petrol engine
   + The power supply system of the diesel engine
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

c9b0dd5c

Removal and installation of a fuel tank

REMOVAL

 PERFORMANCE ORDER

The preventions resulted in Section the General information and safety measures see.

1. The drain stopper in a fuel tank is not provided, that is why its dismantle is expedient for making after a definitive devastation. Do not forget to disconnect preliminary the battery, having disconnected from it a negative wire. The fuel rests can be pumped out from a tank by means of a syringe or the manual pump.
2. Prop up forward wheels of the car wedges, then поддомкратьте a back of the car and establish it on props. Remove the right back wheel.
3. Uncover access and disconnect electroconducting and hoses of giving and return of fuel from the top part of assemblage of a gasoline pump/gauge of the expense of fuel.

4. Under the car release worm collars and disconnect from a tank a tube of a jellied mouth.

5. Release fixing clips and liberate cables of a drive of a lay brake from directing clamps on assembly скобе a fuel tank, and also both ends of a beam of the back bridge. Shift cables aside and tie up their wire.

.6 Prop up a tank, then give bolts assembly скоб. Turn скобы downwards and lower a tank. Pay attention that one of bolts assembly скоб a tank is used also for support fastening подвеса systems of release of the fulfilled gases - tie up corresponding section of system. At tank lowering track, that it did not cling the components located in immediate proximity. Take a tank from under the car and merge from it last rests of fuel. Закупорьте all apertures in order to avoid hit in a dirt tank.

.7 In case of hit in a tank of water or revealing of signs of strong internal pollution, wash out a tank pure fuel. It is necessary to deliver a proceeding tank for check and repair in a specialised workshop.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Pay attention to following moments:

a) At поднимании a tank in regular position try not to clamp any fuel hoses;
b) Track correctness of a lining and reliability of fastening of all lines. Make sure that hoses are not overwound;
c) Bolts assembly скоб tank fastenings should be tightened with demanded effort;
d) In summary fill in in a tank fuel and check up on presence of signs of leaks.