Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   + The power supply system of the diesel engine
   - Systems of decrease in toxicity and release of the fulfilled gases
      System of catching of fuel evaporations - the general information and replacement of components
      Ventilation system картера - the general information
      Removal and l-probe installation
      System recycling the fulfilled gases (EGR) - the general information and replacement of components
      Removal and installation of a final collector
      Release system - the general information and replacement of components
      The Katalitichesky converter - the general information and safety measures
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

System recycling the fulfilled gases (EGR) - the general information and replacement of components

REMOVAL

PERFORMANCE ORDER

1. The oxygen gauge will screw in a reception pipe of system of release of the fulfilled gases ahead каталитического the converter.

2. Disconnect a negative wire from the battery.

3. Disunite a socket of electroconducting of a l-probe. The socket is fixed in an arm established on a casing of the thermostat. If in an arm two sockets necessary will be bottom of them are fixed. Расстыковав a socket, liberate the tip from an arm.

As the part of a plait of electroconducting is built in in the gauge case for a reversing of the last it is required special накидной a key with a cutting head. Working under the car, turn out a l-probe from section of system of release. Try not to damage a sensitive working element of the gauge.

INSTALLATION

PERFORMANCE ORDER

1. Slightly grease a carving part of the gauge with antitaking hermetic which case it is not necessary to suppose hermetic hits on a working element of the gauge.
2. Establish the gauge in the casing and tighten it with demanded effort. Restore initial connection of electroconducting. It is necessary to pay attention of readers that on various cars the l-probes of various type which are not the interchangeable can be established.