Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


c9b0dd5c

Removal and installation electromagnetic запорного the valve

The preventions resulted in Section the General information and safety measures see.

At the moment of drawing up of the present Management replaceable запорные valves in an individual order (separately from ТНВД) were not issued. In case of occurrence of problems address to experts of car-care centre.

REMOVAL

 PERFORMANCE ORDER

1. The zapornyj valve is established in back part ТНВД.
2. Disconnect a negative wire from the battery.
3. Remove from the valve the top cover.
4. "Walk" on electroconducting from the case of the valve to the management block иммобилизатора anticreeping system. Turn out a bolt, remove the remote plug and remove the block of management from basis ТНВД.
5. Turn out the case of the valve from a pump body, covering with a key on шестигранное moulding in the valve basis. Try not to pull electroconducting. Remove a sealing ring, take a spring and плунжер.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Do not forget to replace a sealing ring. Track reliability of a tightening of the case of the valve.