Skoda Felicia

Since 1994 of release

Repair and car operation


Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

c9b0dd5c

Check and adjustment of the maximum turns of the engine and idling turns

The gazoraspredelitelnyj belt should be in good repair as at the maximum turns of the engine loading also essentially increases by a belt. Remember that belt breakage can result to serious irreversible damages of a head of cylinders.

The preventions resulted in Section Removal from the car of the power unit - preparation and safety measures, the general data on a suspension bracket of the power unit see.


The maximum turns

 PERFORMANCE ORDER

1. Start the engine and warm up it to normal working temperature.
2. Make sure that the lay brake is reliably cocked, and control lever РКПП is translated on neutral transfer. Ask the assistant to squeeze out against the stop an accelerator pedal.
3. By a special tachometre for diesel engines measure the maximum turns. Compare result of measurement to requirements of Specifications.

It is not necessary to keep the engine on the maximum turns more than two-three seconds continuously.

4. In case of need updating carrying out remove the wire lock and a protective cap from the adjusting screw. Release a counternut and screw rotation make necessary updating.

5. Make sure of correctness of the exposed value, then strongly tighten a counternut. Establish into place a protective cap and the wire lock.


Idling turns

Updating of turns of idling is carried out by means of the adjusting screw (2). The screw is stopped from rotation by a counternut.