Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Check and updating of installation of phases of injection ТНВД


In view of responsibility of procedure, its performance will charge more correctly to the qualified mechanic of a car repair shop.

1. Result the piston of the first cylinder in position ВМТ (see Has undressed Reduction of the piston of the first cylinder in position of the top dead point (ВМТ)).
2. Turn out a stopper on ТНВД and insert into an aperture an adapter and циферблатный a measuring instrument плунжерного type. Turn a cranked shaft on 90 in a direction opposite to the normal. Null a measuring instrument.

3. Turn a cranked shaft in a normal direction before coincidence of labels ВМТ. The measuring instrument should fix value Х + 0.15 mm. The size Х is designated on the lever of giving of fuel ТНВД.

1 — the Counternut
2 — the Adjusting screw
3 — a cable Tip
4 — the Counternut
5 — the Place of measurement of the size Х adjustments of the moment of injection

4. If the result of measurement differs from stipulated, ослабьте bolts of fastening of a flange of the pump and develop last in a corresponding direction, achieving demanded value.
5. Repeat check.
6. Upon termination of works turn out a transitive nozzle and establish into place a stopper with a new washer.