Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Removal and installation of assemblage of an air cleaner and components of an inlet path


Air cleaner


1. Take filtering element of an air cleaner.

2. In an impellent compartment compress flat-nose pliers of a leg of the big spring collar and disconnect a sleeve of giving of air from a cover of the inlet pipeline.

3. The air cleaner casing is located on a mudguard of an arch of the right forward wheel and fixed by means of a plastic nut. Two rubber support of a casing are thus passed in apertures in a mudguard. Give a nut, liberate rubber support and take a casing of an air cleaner from an impellent compartment.
The inlet pipeline with a cover

4. Turn out five bolts of fastening of a cover of the inlet pipeline.

5. Remove a ventilating branch pipe from a camshaft cover, or release a collar and disconnect a branch pipe from a cover of the inlet pipeline.

6. If have not done it earlier, release a collar and disconnect an inlet air line.

7. Lift a cover of the inlet pipeline, having cast away it back on an impellent compartment. The cover is dressed on inlet air branch pipes and cannot be removed from them before pipeline removal. Check up a condition of a rubber sealant, in case of need make replacement.

8. Turn out bolts of fastening of inlet air branch pipes - bolts are used also for pipeline fastening - and remove assemblage of the pipeline with branch pipes and a cover from a back part of a head of cylinders. Remove an adjusting lining of the pipeline.



Installation is made upside-down. If removal of the inlet pipeline was made, do not forget to replace a sealing lining. Check up a condition and passableness of a ventilating branch pipe. In case of need clean it, or replace.