Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Check of installation of turns of fast idling


The preventions resulted in Section Removal from the car of the power unit - preparation and safety measures, the general data on a suspension bracket of the power unit see.

1. The valve of increase of turns of idling is established in a back part of an impellent compartment, near to electromagnetic valve EGR, and equipped by an electric socket of grey colour. The device functions at warming up of the cold engine, and also at loading increase on engines during the equipment inclusion which functioning leads to decrease in turns of normal idling (head headlights, a heater of back glass, etc.). By a principle of action the device can be compared not with compulsorily operating air заслонкой on petrol engines, and, more likely, to the device of stabilisation of turns of idling. The procedure for test of serviceability of functioning of the device is more low described.

2. Check up correctness of installation of turns of normal idling, in case of need make corresponding updating.
3. Start the engine, then include the greatest possible quantity of onboard consumers of the electric power.

It is supposed that the battery and system of a charge of the car function regularly. Idling turns should not fall considerably.

4. On the heated-up engine disconnect a hose from a vacuum capsule of the valve of the device of increase of turns. Turns should rise to the value stipulated in Specifications.

5. Possibility of adjustment of the device of increase of turns of idling is not provided. In default or infringements of serviceability of functioning of the valve check up a condition of a vacuum hose. Also make sure that приводной the cable is not overwound. The cable should be adjusted so that between тросовым a clip and the executive lever was available small люфт. The faulty valve is subject to replacement.