Skoda Felicia

Remove the panel of an internal upholstery of a door (see Has undressed Removal and installation of panels of an internal upholstery of doors).

1. Turn out fixing screws, remove washers, disconnect the internal handle from an executive rod and remove it from a door.
2. Accurately separate from a door an upper edge изоляционной films for the purpose of providing of access to the regulator mechanism window lifterа.
3. Lower glass so that access to bolts of its fastening to a regulator through a special window in a doorframe has opened.

4. Accurately liberate the bottom sealing tape from a window aperture and remove it from a door.

5. Turn out four bolts of fastening of a windowpane to a regulator window lifterа, remove washers, then lift glass upwards and take it from a door.

1. Execute the procedures described in paragraphs with 2 on 4.

2. Mechanism components window lifterа are presented on an illustration. Turn out four bolts of fastening of glass to a regulator window lifterа, remove washers, then lift glass in the top position and glue its adhesive tape to a doorframe. 1 — the Cover 2 — Terminators of moving of glass 3 — the drive Handle window lifterа

3. On the models equipped with the electric drive Glass lifts, release a clamp and disunite an electroconducting socket drive the motor.
4. On all models give nuts of fastening of assemblage of a regulator to a doorframe, remove washers, then accurately take assemblage through the provided aperture.

1. Turn out screws of fastening of the internal handle of the lock, remove washers, then disconnect the handle from an executive rod of the lock and remove it from a door.
2. Accurately separate from a doorframe an upper edge изоляционной films for the purpose of providing of access to the regulator mechanism window lifterа.

3. Completely lower glass, then liberate from a doorframe the bottom sealing tape of a window aperture.

4. Give fastening screws to a door of a directing trench to a door, then take from a doorframe assemblage of a trench with the fixed glass of a back window leaf.

5. A marker lead round on perimetre of a washer of bolts of fastening of glass to a regulator window lifterа.
6. Turn out bolts of fastening of glass, remove washers, then lift glass upwards and take it from a doorframe.

2. A marker lead round washers of bolts of fastening of a windowpane to a regulator window lifterа.
3. Turn out bolts of fastening of glass to a regulator, remove washers, then lift glass in the top position and glue its adhesive tape to a doorframe.
4. Give nuts of fastening of assemblage of a regulator to a doorframe, remove washers, then accurately take assemblage through the provided aperture.

Installation is made upside-down. Pay attention to following moments:

a) Track correctness of installation of sealing tapes of window apertures;
b) At glass installation track correctness of its landing in directing trenches. Strongly tighten bolts of fastening of glass to a regulator;
c) Before to establish into place изоляционную a film and the panel of an internal upholstery of a door (see Has undressed Removal and installation of panels of an internal upholstery of doors), check up serviceability of functioning window lifterа. In case of need insignificant adjustment can be made by easing of fixing bolts and updating of position of glass on a regulator.