Skoda Felicia

Since 1994 of release

Repair and car operation

Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      The description of the basic knots and mechanisms
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
      Check of tightness of chambers of combustion
      Removal and installation of a belt of drive ГРМ and its covers
      Removal and installation натяжителя and cogwheels of a belt of drive ГРМ
      Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of a camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a cranked shaft
      Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assemblage маслозаборника
   + Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units

The general information

The auxiliary belt is used for a drive from a pulley of a cranked shaft of such devices, as the generator, steering and water pumps.

The multicostal auxiliary belt is equipped by the device of automatic adjustment



1. Park the car on an equal horizontal platform, cock a lay brake and prop up wedges back wheels. Release nuts of fastening of the right forward wheel.
2. Поддомкратьте redock of the car also establish it on props. Remove the right forward wheel.
3. Turn out fixing screws and uncover a belt.

4. Check up a belt on presence of factory directional markers of rotation. In case of need put corresponding marks independently.
5. A rozhkovym key on 15 mm develop a roller натяжителя counter-clockwise, overcoming effort of a spring.

6. Remove a belt from a generator pulley, then from other pulleys.

Installation and tension adjustment


At belt installation be guided on marks of a direction of its rotation.

1. Throw with a belt a pulley of a cranked shaft. Track that edges of a profile of a belt have taken places in the correct image in pulley streams.
2. Overcoming resistance of a spring, рожковым a key develop a roller натяжителя counter-clockwise.
3. Get a belt the flat party under a roller натяжителя, then put on it the remained pulleys. Track hit of edges in streams.
4. Having released a roller, allow it to pull a belt.
5. Establish into place a cover and strongly tighten screws of its fastening.
6. Establish a wheel, lower the car on the earth, then tighten bolts of fastening of a wheel with demanded effort.