|
1. Remove a belt of a drive of auxiliary units (see Has undressed Removal, installation and adjustment of effort of a tension of a belt of a drive of auxiliary units).
2. Remove pulleys auxiliary drive a belt and the top cover газораспределительного a belt, then result the piston of the first cylinder in position ВМТ of the end of a step of compression, remove газораспределительный its belt натяжитель and a camshaft cogwheel (see Has undressed Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression, Removal and installation of a belt of drive ГРМ and its covers, Removal, check of a condition and installation of cogwheels and натяжителя a belt of drive ГРМ).
3. Having turned out fixing bolts, remove from the engine a back (internal) cover газораспределительного a belt.
|
|
4. Operating according to the instructions resulted in corresponding Sections of the present Chapter, execute following procedures:
a) Otboltite a cover of the first bearing of a camshaft also take an epiploon;
b) Grease a new epiploon with pure impellent oil and establish it on a camshaft pin;.
c) Grease an interfaced surface, establish a cover of the first bearing of a camshaft and in stages tighten nuts of its fastening with demanded effort. |
5. Operating in an order, the return to a dismantle order, establish into place all components acting in film with a view of providing of access. Do not forget to make tension adjustment газораспределительного and auxiliary belts. |
