Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
The general information
System design, the description of separate knots and mechanisms
Prorolling of hydraulic system
Replacement of hoses and tubes of a hydraulic path of brake system
Replacement колодок disk brake mechanisms of forward wheels
Replacement of boots of drum-type brake mechanisms of back wheels
Condition check, removal and installation of disks of forward brake mechanisms
Removal, check of a condition and installation of drums of brake mechanisms of back wheels
Removal, major repairs and installation of supports of brake mechanisms of forward wheels
Removal, major repairs and installation of wheel cylinders of back brake mechanisms
Removal, major repairs and installation of the main brake cylinder (ГТЦ)
Removal and installation of a pedal of a foot brake
Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
Removal, check of a condition and installation of the control valve of the vacuum amplifier of brakes from a hose
Adjustment of a lay brake
Removal and installation of the lever of a lay brake
Removal and installation of cables of a drive of a lay brake
Check of serviceability of functioning, removal and installation of the valve-regulator of pressure in hydraulic contours of brake mechanisms of back wheels
Removal, installation and adjustment of the gauge-switch of stoplights
System of antiblocking of brakes (ABS) - the general information
Removal and installation of components of systems ABS
Removal and installation of the vacuum pump (diesel models)
Check of a condition and major repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment
|
Removal, check of a condition and installation of the control valve of the vacuum amplifier of brakes from a hose
REMOVAL
|
|
|
1. The control valve is built in a vacuum hose of the servo-driver of the brake amplifier.
|
|
2. Cautiously liberate a vacuum hose from the servo-driver block, take the rubber plug through passage. |
|
|
3. Moving back along a hose, liberate it from all intermediate clamps, then release a collar and disconnect a hose from the inlet pipeline / the vacuum pump. Take assemblage of a hose from an impellent compartment. Do not try to take out the valve from a hose. |
|
|
CHECK
|
|
|
1. Attentively examine the valve with a hose on presence of signs of mechanical damages. In case of need make replacement. Check испрвности valve functioning can be made a way продува it in both directions. Air should pass through assemblage only in one party - from outside the vacuum amplifier. Otherwise the valve is subject to replacement.
2. Check up the rubber plug of the valve through passage on presence of damages and signs of ageing of a material. In case of need make replacement. |
|
INSTALLATION
|
|
|
1. Installation is made upside-down. Track correctness of a lining of a hose and reliability of a tightening of a fixing collar.
2. Densely plant the plug through passage in the block of the servo-driver and pass in it the trailer union of a vacuum hose (try not to damage the plug).
3. In summary start the engine and check up corresponding components on presence of signs of leaks of air. |
|
|
|
