Skoda Felicia

Since 1994 of release

Repair and car operation


Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   - Repair without extraction from the car of the petrol engine of 1.6 l
      The description of the basic knots and mechanisms
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
      Check компрессионного pressure - an order of carrying out and interpretation of results
      Removal and installation of a belt of drive ГРМ and its covers
      Removal, check of a condition and installation of cogwheels and натяжителя a belt of drive ГРМ
      Removal, installation and adjustment of effort of a tension of a belt of a drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of a camshaft
      Replacement of epiploons of a cranked shaft
      Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Removal, check of a condition and flywheel installation
      Check of a condition and replacement of support of the power unit
      Removal and pallet installation картера the engine
      Removal and installation of the oil pump and маслозаборника
   + Repair without extraction from the car of the diesel engine
   + Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment

c9b0dd5c

Check of serviceability of functioning of hydraulic pushers

 PERFORMANCE ORDER

After installation of hydraulic pushers wait not less than 30 minutes before to start the engine (is recommended to transfer start for morning of next day), otherwise it will be impossible to exclude completely risk of collision of pistons with valves!

1. Pushers of valves on the considered engine are equipped by hydraulic jacks that allows to refuse necessity of regular adjustment клапанных backlashes.
2. In case of increase of level of the noise published клапанным by the mechanism, it is necessary to check up serviceability of functioning of hydraulic pushers.
3. Warm up the engine to normal working temperature. On pair minutes lift turns of the engine to 2500 in a minute (turns of fast idling), then muffle the engine. Uncover heads of cylinders (see Has undressed Removal and installation of a cover of a head of cylinders).
4. Turning the engine for a bolt of a cranked shaft, expose a cam of the first cylinder of a camshaft a working ledge upwards.
5. With the help probeа лезвийного measure backlash size between a heel of a cam and an end face of assemblage of a hydraulic pusher. If the result of measurement exceeds 0.2 mm, it is necessary to replace a pusher.

6. At a backlash normal amount (less than 0.2 mm) rest against the top end face of a pusher and wring out it down to an emphasis against the stop in a valve core.

Отжимание a pusher it is necessary to make only by means of the tool made of a soft material (a tree, plastic).

7. If the size of a course of a pusher against the stop in a valve core exceeds 0.2 mm, assemblage is faulty and is subject to replacement.